Shock Doctor MicroFit Mouthguard
Shock Doctor MicroFit Mouthguard are Designed to provide the lowest profile protection in a thin and tight fit design.
The slim fit provides ultimate easy breathing and speaking with I-Mold technology for smooth contour.
The Shock Doctor MicroFit Mouthguard gives a high level of comfort after forming the mouthguard to each athlete's unique preference for fit.
The new HMW composite blend adds increased durability while maintaining fit and performance all season long.
- Ultra Custom, Lowest Profile
- Exclusive I-Mold Technology
- Easy to Speak, Breathe, and Drink
- Low-Temp Fast Fit
- $10,000 Dental Warranty
Available in White, Black, Red, Blue, Shock Green, Shock Pink and Shock Orange
NO BOIL – LOW HEAT FITTING INSTRUCTIONS
ALWAYS protect mouthguard from heat environments such as hot dashboards and hot car interiors.
NEVER CHEW or DISTORT mouthguard which can damage it and reduce fit and effectiveness. STORE at Room Temperature, preferably in a clean mouthguard case. CLEAN and Rinse after each use.
- Large Clear safety glass measuring cup or bowl
- Hot water – Not Boiling (Approximately 140-150 degrees F Max.)
- Slotted spoon or fork
Heat water to between 140 F and 150 F. DO NOT BOIL. Water should be just hot enough that you can’t quite dip your finger in it.
Place mouthguard in water, detailed side up, until MicroFit mouthguard softens. Check the softness of the mouthguard with the spoon or fork. DO NOT KEEP IN WATER TOO LONG. This could be 30-40 seconds.
Once mouthguard is soft, carefully remove MicroFit mouthguard from water with a slotted spoon or fork.
Keep MicroFit mouthguard flat. If needed, you can gently pull/stretch the MicroFit mouthguard if it looks like it has shrunk in size. Do not let it fold over onto itself.
Do not rush – you have time to get a great fit
While looking in the mirror and using two hands to support the MicroFit Mouthguard, place the mouthguard in your mouth with front teeth centered and aligned with the recessed center guide to line up teeth in the middle of the guard. Bite down gently. Carefully remove the MicroFit mouthguard and look at the teeth impressions to make sure they are centered along the arch. If not centered, realign.
Gently bite down on MicroFit mouthguard and use tongue to press the material into back of teeth while lifting and pressing the edges up on the front teeth with your fingers. Use fingers to mold the MicroFit mouthguard to cover the rest of your teeth. Press evenly.
With teeth firmly clenched on the whole mouthguard, close lips and begin to suck out air until the MicroFit mouthguard hardens to a close, comfortable fit. Continue to push on the lips and cheeks to form.
If you are unhappy with your fit, simply place your formed MicroFit mouthguard back in the hot water and wait for the material to soften and repeat fitting. If needed, you can gently pull/stretch the mouthguard back to a flat shape.
DO NOT OVERHEAT.
Posted by Hollywood on 3rd Jun 2016
I bought this mouthguard after wearing a Sisu mouthguard. I only had to form the Shock Doctor mouthguard once and the fit was perfect. It is slightly thicker between the teeth compared to the Sisu which is good if you're like me and you tend to grind or clench your teeth. Despite being a little thicker, I can still talk and drink water easily while wearing the Shock Doctor mouthguard. I would highly recommend this product!